FAQ's
Can I use the cylinder stroke partially, and possibly modify it, or must I always use 100% of the nominal stroke? | You can use any percentage of the nominal cylinder stroke and you can always adjust it according to your requirements and without any limits. |
Is it possible to block the rod return in any position? | Yes |
Is it possible to adjust the return speed of the rod? | Yes |
Is it possible to adjust the return speed of the rod? | Speed and rate vary from installation to installation. For further information, contact Special Springs’ technical office. |
Is it possible to use cylinders of different sizes and strokes within a single installation? |
Yes. For further information, contact Special Springs’ technical office. |
How does the contrasting force behave during the rod com- pression phase? | Unless programmed differently, the force remains constant during the whole extent of the stroke. |
What kind of pipes can I use for connecting cylinders inside the tool? | The size and type of pipes vary according to the installation and are usually decided at the dimensioning stage. For further information, contact Special Springs’ technical office. |
How many cylinders can I connect to a single command unit? | IAs a rule, there are no limits. For further information, contact Special Springs’ technical office. |
How are cylinders and command unit connected? | The connection is made by means of flexible hose pipes with quick coupling connectors onto the distribution unit attached to the tool. To connect cylinders and distribution unit, you may use flexible hose pipes or tubular plates suitable for oil flow. |
Can I use the same command unit with different tools? | Yes, you can, provided the specifications of the command unit are suitable for such a use. For further information, contact Special Springs’ technical office. |
How does the fluid which circulates inside the system cool down? | Thanks to the air-oil exchanger which is to be found on the command unit. |
Is it always necessary to cool down the circulating fluid? | Yes. This takes place automatically thanks to a temperature sensor which switches the exchanger on. |
What maintenance does the system require? |
Oil change should occur every 5,000 working hours or every 2,5 years at the latest; always check the oil level before the start of a new production process; fill up if necessary. All cylinders are maintenance friendly. |
How do I make sure that the installation gets the input it needs for it to function? | Just interface the command unit with the Press control unit. |
Can I use the Special Springs system with any type of Press? | Yes |